|
: Group 3E Series Production Cars is an Australian motor racing formula for production based cars competing with limited modifications. Group 3E cars formerly contested the Australian Manufacturers' Championship and Australian Production Car Championship titles and the annual Bathurst 12 Hour endurance race. Regulations for production car racing in Australia were first formalised in 1964 when the Confederation of Australian Motor Sport introduced the Group E Series Production Touring Cars category. This was abandoned at the end of 1972. “Series Production” made a return to Australian motor racing in 1981 when a new set of Group E regulations was issues by CAMS.〔Australian Motor Racing Year, 1981/82, pages 40-44〕 The new Series Production Cars were, like their predecessors, intended to be mass-produced vehicles made suitable for competition by minimal modifications. Eligible cars were limited to those with an engine capacity of less than 4500cc and only vehicles which CAMS specifically chose to include on a model eligibility list could compete.〔CAMS Manual of Motor Sport, 1982, page 311〕 Classified drivers were banned and the category was intended to be a second level category with no championship, run only at restricted race meetings. For 1984 CAMS announced a revision of the rules, with a wider range of models now eligible to race in Group E and freely available optional equipment (such as limited slip differentials) now permitted.〔Australian Motor Racing Year, 1983/84, pages 78-82〕 The advent of the Bob Jane Super Series in 1984 saw the class take a major step forward. With prizemoney totalling $200,000 the Super Series was richest motor racing series in Australia at that time. Special dispensation was granted to enable classified drivers to compete and cars fitted with turbocharged engines were now permitted.〔Australian Motor Racing Year, 1984/85, pages 62-67〕 1987 saw the running of the inaugural Australian Production Car Championship, open to drivers of Group E Series Production cars and contested over two races at a single race meeting at Winton Raceway in Victoria.〔Australian Motor Racing Year, 1987/88, page 281〕 In 1988 Group E was officially redesignated as Group 3E Series Production Cars.〔CAMS Manual of Motor Sport, 1988, page 81〕 and in the same year the Australian Production Car Championship was expanded to a series format and attracted sponsorship from the Yokohama tyre company.〔Australian Motor Racing Year, 1988/89, pages 199-200〕 For 1990 turbocharged cars were banned and Group 3E became a class for family orientated naturally aspirated sedans.〔Australian Motor Racing Year, 1990/91, pages 164-165〕 1994 saw CAMS limit the class to front wheel drive cars of under 2.5 litre engine capacity.〔Australian Motor Racing Year, 1994/95, page 202〕 The 2.5 litre cars would only contest one more Australian Production Car Championship as that title was replaced by the Australian GT Production Car Championship in 1996. The new title, which was contested under revised Group 3E regulations,〔(Australian GT Production Car Championship overview ) Retrieved from web.archive.org on 18 November 2008〕 permitted a much larger variety of models to compete including GT type cars such as Porsche, Ferrari and Lotus. The year 2000 saw the Australian GT Production Car Championship split into the Australian Nations Cup Championship (for GT type cars) and the Australian GT Production Car Championship (for other production based vehicles) with Group 3E regulations covering cars competing in both titles.〔Sporting Regulations for the 2002 Australian National Cup Championship〕〔Sporting Regulations for the 2002 Australian GT Production Car Championship〕 The Australian Nations Cup Championship was moved away from Group 3E regulations for 2003 with a greater level of modifications permitted to the cars. The same applied to certain high performance models from the Australian GT Production Car Championship which would now contest the Australian GT Performance Car Championship. From this time Group 3E regulations applied only to the remaining cars which would contest the annual Australian Production Car Championship 〔Sporting & Technical Regulations for the 2003 Procar Championship Series - CAMS Bulletin B03/023 of 4 March 2003〕 resurrecting the title which was last awarded in 1995. The Bathurst 12 Hour endurance race was revived in 2007 as an annual event open to Group 3E cars.〔2007 Bathurst International Motor Festival - 12hour Category Supplementary Regulations – Final 10.11.06〕 For 2008 the Australian Manufacturers' Championship title was reinstituted and contested concurrently with Australian Production Car Championship.〔2008 Australian Manufacturers Championship Sporting Regulations – CAMS Bulletin B08/098〕 This would mark the first time since 1972 that the Australian Manufacturers title had been open to Series Production vehicles. ==References== 〔 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Group 3E Series Production Cars」の詳細全文を読む スポンサード リンク
|